Heat pump or furnace? That is the first thing that matters when the heat quits in Pasco, WA, because the two fail in completely different ways. Heat pumps tend to ice over when defrost stops working, get stuck in cooling when a reversing valve fails, or quietly lean on the electric backup strips, at several times the normal operating cost, when the outdoor unit dies. Gas furnaces usually come down to the flame sensor: once oxide coats it, the burners light but the flame cannot be proven, so the board cuts the gas and locks out after three tries. After that, we most often find cracked hot surface igniters, stuck pressure switches, clogged condensate traps on high-efficiency models, and blower motors at the end of their life.
The repair homeowners call us about most is Furnace Repair. Start there if your system isn't running right.
When to Call for Heating Repair in Pasco
The sooner you notice these red flags, the easier and cheaper the fix. These are the signals our technicians see most often:
- Clicking and failed ignition attempts before the furnace gives up
- Strange smells from the vents, especially rotten egg or burning
- An outdoor heat pump coil that stays iced over
- A loud boom when the burners light, which points to delayed ignition
- The system starting and stopping every few minutes without warming the house
- Cold rooms in one part of the house while others are comfortable
- No warm air at the registers even with the heat turned up
- Higher heating bills with less comfort to show for them
Don't Wait for a Total Failure
Most HVAC failures start small, a weak capacitor, a squealing blower, a system that runs a little longer each week. Call (208) 208-1913 at the first sign of trouble.
